MIG Welding Machine Aluminum Spool Gun Wire Feed Feeder for HITBOX MIG Welder Specification: Rated Welding Current CO2:200A Mixed Gas: 160A Duty Cycle :35% Wire Diameter :Mild Steel 0.4-0.8mm Stainless Steel :0.6-0.8mm Aluminium :0.6-1.0mm Wire Speed : 0~16m/min Spool Cover Diameter :φ102mm Motor Voltage : DC 24V Speed Adjust Potentiometer :10kΩ(1kΩ/5kΩ) Cooling System :Air cooling Changeable Gun Neck : Straight neck/Goose neck Connection : Euro-central Criterion: GB 15579.7-2013 Welding mode: MIG/MAG Guiding mode: manual Rated voltage: ≤113V Rated electrical controlling rate: 24V How to Use: 1.Switch off welder power, make the Euro-central connector connect with wire feeder adaptor ,and tighten threaded collar. Insert plug into receptacle , and tighten threaded collar. 2. Installing wire spool Press the button on the spool cover then open it, loose the spool cover fixing screw (levo), slide wire spool to it’s shaft, Adjust nut to make it suitable. Push wire through guides into wire feeding roll. Press the trigger after closed the cover, wire feeding roll make the wire into the gun tube. 3. Adjusting the wire feeding pressure Turn the pressure adjusting screw clockwise with hand, the pressure will increase, otherwise it will decrease. 4. Adjusting the wire feeding speed Turn the wire feeding speed adjusting knob clockwise, the speed will increase, otherwise it will decrease. Packing List: 1X spool gun(Not included welding stick)